Consolidated Thermal Solutions and Designs for Advanced Processors

TennMax Lasagna iOp Cooler
Capable of cooling 25 Watt processors

Installation tips and pictures

Application note:   (5.9.00)

1. The cooler has TennMax proprietary thermal interface change pad attached.  Users do not need to apply thermal compound (grease) to install this cooler.  Thermal compound can cause complication of "freezing the motor shaft.

2. Also, the micro fan is a delicate part, please do not spin the fan with your finger, or apply any pressure to the shaft. If you do so, it may damage the motor and shorten the life of the cooler.

iOp on 1.jpg (83857 bytes)
.

io connector.jpg (67408 bytes)
Power cord pin placement


To reduce the noise cause by restricted air flow by the shield,
follow the pictures shown here
IO area to cut.jpg (54839 bytes)
.

IO shield back.jpg (43258 bytes)
This small opening should not reduce the shielding effectiveness of this metal shield
Also, the fan itself has been approved by FCC on RF interference specification.

IO cover back.jpg (51325 bytes)
fan should be much quieter with more air flow

iop on S7.jpg (62422 bytes)
Socket 7 Clip
Use a flat end screw driver to push down the tab
and pull away form the socket to release the cooler

back to iOp page

[ Home Page][order information]