TennMax CLN TF Cooler for Celeron

"An Overclockers' delight"

"The BEST Celeron Cooler" reviewed by Overclockers.com
reviewed by HardwareCentral
reviewed by Heatsink-Guide
Interesting comment by NATHAN L. FIEDLER, "No more water!"

• Two high quality, long lasting, quiet ball bearing fans.
• One 3-wire to motherboard connection for both fans
• TennMax special thermal interface pad attached.
• Easy and secure clip design .
• High thermal conductive Aluminum Alloy.
• Extruded with micro grooves on the fins for high surface area.
• Design for aggressive overclocking all Celeron processors

Installation instruction:

1. Remove the OEM fan/sink on the processor by releasing the clips. Use a flat-end screw driver to release the 4 clips, one by one.
2. Use a hairdryer to blow hot air on the heatsink. This will soften the compound under the sink and make it easier to take the heatsink off.
3. Clean up the compound left on the processor. Any solvent will do.
4. Separate the clip from Celeron TF and reattach them with the processor in between them. Push the clips, one by one (with some pressure) into positions.
5. Once the clip is securely attached, place the processor back into to the Slot, and you are ready to go.

Note: This TF Cooler is designed for Celeron procesosr fit in SLOT 1 only.  You need ULTRA or MEGA7 Cooler for Celeron PPGA on Socket 370 (here).

[ Home Page][to order]